Step One

Cut approx 30" of 1mm wire and holding the mandrel in the centre of the wire at the correct point for your chosen ring size, wrap the wire around twice then bring both wires up to the same point.

Step Two

Keeping the wire on the mandrel, place your thumb over the middle of all the wires and bend each one around into a tight spiral.

Step Three

Thread on a 6mm round gemstone and wrap the wire around it three or four times forming a collar, then trim off any excess wire and tuck in any sharp edges

Step Four

Repeat Step 3 on the other wire to complete the first ring.

Step Seven

Using Round Nose Pliers make a 'wiggle' with one of the wires by bending the wire around the tip of the plier jaws.

Step Eight

Thread on the 4mm round gemstone and wrap the tail of the wire around it a few times and trim off any excess to complete the second ring.