Step One

Take the gold chain and cut 2 x 15cm and 4 x 10cm lengths.

Step Two

Using 2 gold jump rings attach the toggle clasp to the 15cm lengths of chain.

Step Three

Thread a jasper tube onto an eyepin. Bend the tail over to form a right angle. Using round nose pliers roll the tail over to form a neat loop. Repeat this another 3 times. To create 4 jasper connectors.

Step Four

Open one end of the jasper eyepin and put onto one end of the 15cm lengths of chain and close the loop. Do the same for the other side of the necklace.

Step Five

Open the bottom loop of the jasper connector and add a 10cm section of chain and close. Do the same for the other side of the necklace.

Step Six

Attach another jasper connector to the end of these lengths of chain.

Step Seven

Add the last two lengths of chain to the end of the jasper connectors.

Step Eight

Open a jump ring, add on the two ends of the chain and add on a large skeleton leaf and close. With another jump ring add two of the small gold leaf charms to the loop on the skeleton leaf.

Step Nine

Using jump rings, attach a small skeleton leaf to the 4th chain link from the first jasper connector. With another jump ring add a small gold leaf charm to the loop of the skeleton leaf. Do the same on the other side.

Step Ten

Using jump rings attach the last two large skeleton leaves to the 2nd chain link under the second jasper connectors on either side. To finish, add small gold leaf charms to the leaf loops.